Find retailer

Pro Primer

Paint indoors, Primer

Indoor primer for highly absorbent substrates, such as plaster, concrete, gypsum board, fibreboard, fiberglass cloth, etc. The product is suitable for more glossy wall paints and for most substrates before wallpapering.

Technical details

Gloss: Fully-matte
Consumption: 5-9 m2/L
Dust dry: 1 h
Repaintable: 3 h
Application temp: Min +5°C
Tools: Brush, roller, air brush
Storage:
Recycling: Do not pour remainings down the sink. Leave at waste collection center.

Application

Before applying the product
Always start by reading the instructions on the container, and remember to be meticulous from the very start of the paint job. The proper tools and careful preparations, are prerequisites for successful results. Stir the paint thoroughly before you start applying the product. The ambient temperature is another factor that determines the end result. Do not apply the product if it is colder than +5°C. The surface to be treated must be clean, dry and solid. Wash any previously painted surface with paint wash and rinse with water. Chalky surfaces, such as ceilings with whitewash or distemper, should be washed and primed with Blocka before application of the product. Surfaces with glossy alkyd paint must be sanded to a dull finish before the product is applied. Any iron parts such as nail heads should be primed with anti-corrosive paint first. If painting on a paper wallpaper, you should make a trial application to make sure the wallpaper does not peel off when painted with a water-based product. In such a case, prime the surface using a suitable blocking paint, e.g. Blocka. This is also recommended when applying the product on surfaces damaged by smoking, soot or water. Remember to protect floors and furniture before starting the application.

 

Applying the product
Apply at least two coats of the undiluted product, using a roller, brush or – after thinning – with a spray gun. Ceilings must have a generous covering with the product in order to avoid uneven coverage and streaks. Apply the product cross-wise on ceilings, and apply the last strokes towards the point where light enters the room. Apply the product to the entire wall or ceiling in one go.

 

After applying the product
Wipe off any excess product before cleaning the tools with water. Close the lid of the container properly before storing it out of reach of children. Any residue of the product should not be disposed of in the drains, but should be disposed of in a proper and approved manner. The reason for this is that the product will cause problems in the sewage treatment plant. We care about the environment, and so should you.

  • Name
    Article no.
  • Pro Primer White 10L

    10200001

  • Pro Primer White 3L

    10200301

Calculate paint amount
Calculate paint amount
You need in total approximately X liter paint of Pro Primer for 1 stroke on a surface of 1 sqm
Note, calculation is an approximation and the true amount of paint needed may vary depending on the surface
9
5